27.09.2020

Asus router

Recommendations

1. By default, login is admin, password is admin.

2. Our specialists must change the password in the settings to the Serial number indicated on the box (S / N). When reconfiguring, it is also recommended to use wi-fi S / N (serial number) as the password for the router.

3. Resetting the router is done by pressing and holding the Reset button on the rear panel of the router for 10 seconds.

Authorization

In order to get to the web interface of the router, you need to open your Internet browser and type User Name admin, Password – admin in the address bar (provided that the router has factory settings and its IP has not changed).

Change factory password.

For security reasons, it is recommended that you change the factory password.

Default: login admin, password admin.

Our specialists must change the password in the settings to the Serial number indicated on the box (S / N). When reconfiguring, it is also recommended to use wi-fi S / N (serial number) as the password for the router.

In the router interface, go to the tab (System Setup), then (Change Password)

In the (New Password) field, enter the new password. In the next field it must be repeated.

Next, save the settings by clicking the “Save” button

Configure Wi-Fi on the router.

In the router interface, select the tab on the left (Wireless), select (Interface) in the list that opens.

We set the parameters as follows:

1. “SSID” field: enter the name of the wireless network. The value in this field can not be changed. 2. Authentication Method: WPA-Auto-Personal3. WPA Encryption (WPA Encryption): TKIP + AES4. WPA Pre-Shared Key: You must enter any number of numbers between 8 and 63. You must also remember them so that you can specify them when connecting to the network. 5. It is recommended to use the serial number of the device as a key (indicated on the box, in the form S / N ########).

Click the “Apply” button below

Setting up an Internet connection.

In the router interface, select the tab on the left “IP Config”, in the list that opens, select “WAN & LAN “.

Leave a Reply

Your email address will not be published. Required fields are marked *